Is $1,800 to recharge a multi-split air conditioner with R410A a fair price?
Project Details
I have a reverse cycle multi-split air conditioner with 4 indoor units, installed in 2014, which uses R410A refrigerant (3.30kg). A recent inspection revealed a refrigerant shortage, likely due to a small leak, and some ice buildup on the outdoor condenser coil. Although the system still seems to be heating and cooling well, I've been advised it needs recharging for better efficiency. The system was tested in winter when the outdoor temperature was around 13 Celsius. I'm in NSW, Australia. I can't afford a new air conditioner right now and am considering leaving the current unit for the summer while saving for a new one. I haven't gotten a second opinion yet but plan to.
Quote Details
This quote is for correcting a refrigerant shortage issue in a multi-split air conditioner. - System Type: Reverse cycle multi-split air conditioner - Indoor Units: 4 - Refrigerant Type: R410A - Refrigerant Capacity: 3.30 kg - Problem: Refrigerant shortage due to a small leak, causing ice buildup on the outdoor condenser coil and reduced efficiency. - Scope of Work: Correcting the issue, which includes addressing the leak and recharging the system with R410A refrigerant.
You say...
Vote Distribution
These ratings are not endorsed by Quote Critic. They are submitted by other Quote Critic users like you.
More Details
Category
HVAC
Price
$1,800
Quote Date
October 2, 2025
Year Built
2014
Fuel type
Electric
System type
Air conditioner, Heat pump, Ductless mini Split
Comments
No comments yet
Sign in to share your thoughts and ask questions.
Similar Quotes
Perform comprehensive HVAC system repair and maintenance
This quote covers a comprehensive set of HVAC services, including: - Uninstallation and disposal of the old damaged coil. - Leak free installation of the new coil. - Full system testing and calibration for peak performance. - Uninstallation and disposal of the old damaged filter drier. - Leak free installation of the new filter drier. - Full system testing and calibration for peak performance. - Refrigerant leak detection. - Recover refrigerant. - Nitrogen purge. - Leak repair. - Pressure test. - All refrigerant recovery and recycling following EPA protocol. - Purging refrigerant lines with dry nitrogen. - Accurate refrigerant weigh in/out with calibrated scale. - Complete refrigerant testing for peak system operation using super heat and sub cooling diagnostics. - Adding refrigerant to EPA guidelines. - Remove schrader core with isolation tool. - Install new schrader core and new cap. - Leak test service valve.
Install Mitsubishi 9KBTU Hyperheat Mini Split Heat Pump System for one room
- Perform manual J Load calculation to understand true heating and cooling loads for the area of house served by the furnace - Furnish and install new Heatpump system consisting of Outdoor Unit and Wall Mounted Indoor Unit - Furnish and install Refrigerant piping, interlock wiring and drain tubing - Furnish and install Linehide to cover refrigerant , drain and wire - Furnish and install Condenser Pad - Start up and check test of operation - 1 year labor warranty - 12 year limited manufacturer’s parts warranty
Recharge R410A in AC system
Quote to recharge the R410A refrigerant in the AC system. - Refrigerant Type: R410A - Service: Recharge system - Unit Age: Approximately 5 years old - Note: Technician indicated refrigerant was low and potentially due to a leak, but leak detection was quoted separately.