Other Quotes
Explore quotes shared for Other projects. Use the search below to narrow results.
Add insulation and inject foam in walk-in closet
Quote from a nationwide company to address insulation issues in the walk-in closet. - Add additional insulation underneath the space (garage ceiling below closet) - Inject foam into the outer wall OSB where existing roll insulation is present Contractor's assessment: Primary issue is unconditioned air from the garage below, but also recommends sealing the entire closet space better.
Insulate, trim, and paint a one-car garage
Quote includes: - Insulation for walls and ceilings - Trim work - Painting
Add a 9-foot wall in a basement
Quote to add a single wall in the basement to close off a room. - Wall Length: 9 feet - Location: In basement, between a support beam and another wall - Features: No door, No electrical
Repair mudroom ceiling and wall damage from washer leak
Repair work following a washer leak from an upstairs laundry room into a mudroom. - Demolition of damaged ceiling drywall and back wall covering - Installation of new drywall on the entire ceiling and back wall - Painting of the repaired ceiling and wall (homeowner provided paint) - Replacement of baseboards
Mud a 700 sqft basement
Quote for mudding a basement. - Area: 700 sqft basement - Includes: Materials Note: The work performed was of poor quality, requiring significant rework (fixing over 250 spots) by the hiring contractor's team.
Hang drywall and paint garage walls and ceiling
Quote includes hanging new drywall and painting the garage. - Hang new drywall on 2 walls and the ceiling - Smooth and paint the third wall (shared with the house) - Update existing 2x4 rafters to 2x6 for increased support - Add additional rafters as needed - Drywall finish level: Level 3 - Paint entire garage
Install and finish drywall in basement
Quote includes materials, hanging, and finishing drywall, ready for paint. - Walls: Approximately 1,000 sq. ft. of 1/2” drywall - Ceiling: Approximately 950–1,000 sq. ft. of 5/8” drywall - Includes two soffits (one around an AC run ~12”x24’) - Includes three closets - Ceiling strapping is being done with 2x4 on one side for pipes and 1x3 on the other side.
Add R13 fiberglass batts to basement walls
Quote to add additional insulation to basement walls. - Add R13 fiberglass batts to concrete block walls below-grade. - Walls currently have 2" XPS insulation with R10.
Remove old attic insulation, air seal, and blow in new cellulose
Quote includes the following work: - Remove existing attic insulation - Air seal around top plates, recessed lighting, etc. - Install baffles - Blow in 16" of cellulose insulation
Install rigid foam insulation
Quote to install rigid foam insulation during a siding replacement project. - Type: Rigid foam insulation - Thickness: Approximately 3/8 inch - R-Value: 2.5
Add batts over existing basement insulation blanket
Add insulation batts over the existing builder-installed insulation blanket on the exterior walls of the unfinished basement (~900 sqft). - Scope: Exterior walls only (~120 linear feet) - Work: Add insulation batts over existing blanket - Existing Condition: Top half has original builder-installed insulation blanket - Goal: Qualify for Ontario energy rebate (R14 above)
Install cellulose insulation and air seal attic
Quote option for replacing attic insulation with cellulose and performing air sealing. - Remove existing contaminated insulation - Air seal attic penetrations, including around pancake LED lights - Install cellulose insulation (likely targeting R-60 or higher to meet state code minimum) - Install baffles