HVAC Quotes

Installation of a new 2.5 ton gas and electric HVAC system. - Choice of Trane or Carrier brand equipment - Includes necessary modifications for a 70+ year old home - Standard installation by a preferred local service provider

Recharge the system with refrigerant to address the leak loss. - Add approximately 2 lbs of R410a refrigerant

Labor and professional services to connect a homeowner-installed oil tank and lines to an existing furnace. - Connect copper lines to existing 5-year-old oil furnace - Perform system testing and startup - Homeowner provides tank and copper lines (approx. $2,500 material cost)

Repair of Trane XR unit including part replacement and full system recharge. - Replace low pressure switch (SWT03876) - Supply and install 8.5 lbs of R410A refrigerant - 2.5 hours of labor

Installation of a 42,000 BTU (3.5-ton) dual-zone ceiling cassette system for a 1,100 sq ft space with 12-foot ceilings. - 42,000 BTU Light Commercial Heat Pump Condenser (SEER2 20+) - One 24,000 BTU indoor ceiling cassette with 4-way omni-directional airflow - One 18,000 BTU indoor ceiling cassette with 4-way omni-directional airflow - Professional roof equipment lift using certified crane service - New electrical circuits: 30-40A for outdoor unit and two 15A circuits for indoor units - EPA-compliant R454B refrigerant line sets (25-35 feet per zone) - Built-in condensate pumps with PVC drain lines - Charleston electrical permits and system commissioning - 10-year manufacturer compressor warranty and 1-year labor warranty

Installation of a new Goodman GLXS4B Series Split System Air Conditioner and CAPF Series Evaporator Coil. - Dispose of old equipment and recover refrigerant per EPA regulations - Install new evaporator coil and matching air conditioner (up to 15.2 SEER2) - Seal all seams with UL181 aluminum foil tape and mastic - Connect high and low voltage wiring - Chemically clean and flush copper lines, reconnect with 15 silver solder - Pressure test to 350 psi and perform triple vacuum test below 500 microns - Install new 3-inch plastic pad under the air conditioner - Perform complete system startup, performance, and safety testing - Includes R-32 refrigerant and 10-year limited parts warranty

Installation of a complete 5-ton Carrier HVAC system including: - Carrier Performance 5.0 Ton 454B FSC SEER2: 16.5 - Carrier Up to 18 SEER 5.0 Ton Furnace (58SP0B090V21--20) - Carrier Up to 17 SEER 5.0 Ton 454B Air Conditioner (26TPA860W003) - Carrier 5.0 Ton Upflow/Downflow C Width Coil (CVAMA6021XMA) - REME HALO-LED In-duct Whole home Air Purifier - UV Light system in air handler - 10 year parts and labor warranty - 10 years of servicing including filters and bulbs

Replace existing 20-year-old wall-mounted propane boiler with a new unit. - Removal of existing unit - Installation of new boiler unit (various brands recommended) - Connection to existing pipework and electrical supply - Utilization of existing vent/intake hole

Original installation and repair from July 2025. - Recover all refrigerant from the system - Remove existing evaporator coil and install new OEM coil (Lennox CX34-62C-6F-1) - Install new liquid line filter drier - Properly evacuate and charge system - Install compressor oil lubricant - Add 10 lbs of R-410A refrigerant

- Amana variable 2-stage furnace - 2 ton AC unit - New line set - New whip for disconnect - 2 year parts and labor warranty - Lifetime furnace warranty - Includes $450 rebate

Emergency repair of the existing HVAC unit. - Replace broken motor - Labor and parts included

Full HVAC system replacement including: - Rheem RA16AY 4-ton 2-stage AC (17 SEER2) - Rheem evaporator coil - ThermoFlow PMP112 oil furnace (112,000 BTU) - New Honeywell 3-zone control system and zone dampers - REME Halo LED air purifier - New condensate pump and filter access box - Line set flush and new condenser pad - 10-year parts and 5-year labor warranty - 2-year maintenance agreement