Is $1,230 to repair A/C refrigerant leak a fair price?
Project Details
My A/C was struggling last year due to a small leak, which was temporarily recharged. This week, the leak was identified as being in a weld on one of the lines going to the outdoor condenser. The unit is 5 years old, and the company blames the original installation. The smaller copper line on the condenser was wet. The system was recharged late last summer but couldn't keep up with cooling recently. The quoted price is a guaranteed maximum, and it could be cheaper if less refrigerant is needed for recharge. I'm looking for verification on the leak location and whether the quote seems reasonable.
Quote Details
This quote is for repairing a refrigerant leak in the A/C system. The price includes all wiring, material, equipment, and labor completely installed. - Lock all refrigerant possible into compressor - Dry lines with nitrogen - Re-braze weld joint that is leaking - Remove existing filter drier and replace with new - Pressure test with nitrogen - Pull vacuum on system to proper level - Recharge system with R-410a refrigerant - Test and balance system - Remove all debris created by our installation
You say...
Vote Distribution
These ratings are not endorsed by Quote Critic. They are submitted by other Quote Critic users like you.
More Details
Category
HVAC
Price
$1,230
Quote Date
May 29, 2025
Fuel type
Electric
System type
Air conditioner
Comments
No comments yet
Sign in to share your thoughts and ask questions.
Similar Quotes
Perform comprehensive HVAC system repair and maintenance
This quote covers a comprehensive set of HVAC services, including: - Uninstallation and disposal of the old damaged coil. - Leak free installation of the new coil. - Full system testing and calibration for peak performance. - Uninstallation and disposal of the old damaged filter drier. - Leak free installation of the new filter drier. - Full system testing and calibration for peak performance. - Refrigerant leak detection. - Recover refrigerant. - Nitrogen purge. - Leak repair. - Pressure test. - All refrigerant recovery and recycling following EPA protocol. - Purging refrigerant lines with dry nitrogen. - Accurate refrigerant weigh in/out with calibrated scale. - Complete refrigerant testing for peak system operation using super heat and sub cooling diagnostics. - Adding refrigerant to EPA guidelines. - Remove schrader core with isolation tool. - Install new schrader core and new cap. - Leak test service valve.
Repair a leak and recharge a 1.5-ton AC unit
Estimate for repairing a leak in a 1.5-ton AC unit and restoring refrigerant. - Diagnostic Fee: Checked complete operations and performed diagnostics on the system ($109.00) - Non Specific Repair – Level 2: Non Specific Minor Repair Level 2. Repair leak on copper ($291.50) - Freon – R410A: R410-A Refrigerant Per Pound Installed (8 lbs @ $157.00/lb = $1,256.00) - Total: $109.00 + $291.50 + $1,256.00 = $1,656.50
Perform AC leak detection and refrigerant services
Quote includes the following services to address an AC leak: - Nitrogen based leak detection test: $350+ - Flush existing refrigerant and hold in another tank before pressure test: $650+ - R410a refrigerant: $80+ per pound (additional cost, quantity not specified)