Is $20,000 to install a Mitsubishi mini-split system a fair price?
Project Details
I have engaged the top installers in my area according to the Mitsubishi website. I have had 3 companies come and look and have received 2 quotes. My current system is a Lennox, and I am looking to replace it with a Mitsubishi solution. I plan to use the new system mainly for cooling, with heating as a good backup, as I already have a newer combi unit, radiator, in-floor heating, and hot water heater. I am trying to determine if the quoted price of $18,000 - $20,000 is reasonable.
Quote Details
Installation of a Mitsubishi mini-split system, including a heat pump condenser and four indoor heads. The system is primarily for cooling with heat as a backup. - Heat Pump Condenser: Mitsubishi 36k BTU 22 SEER2 Cold Climate Hyper Heat - Indoor Heads: 4 mounted units - Main Living Area Head: 1 x 18k BTU - Bedroom Area Heads: 3 x 9k BTU - Installation Routing: Heads on interior walls, runs through the garage and up through closets - System Model: MXZ heat pump with MSZ-FS heads
You say...
Vote Distribution
These ratings are not endorsed by Quote Critic. They are submitted by other Quote Critic users like you.
More Details
Category
HVAC
Price
$20,000
Quote Date
July 22, 2025
Location
Minnesota
Brand/model
Mitsubishi MXZ heat pump with MSZ-FS heads
BTU tonnage
36,000 BTU
Efficiency rating
22 SEER2
Fuel type
Electric
System type
Ductless mini Split, Heat pump
Comments
No comments yet
Sign in to share your thoughts and ask questions.
Similar Quotes
Install Mitsubishi 9KBTU Hyperheat Mini Split Heat Pump System for one room
- Perform manual J Load calculation to understand true heating and cooling loads for the area of house served by the furnace - Furnish and install new Heatpump system consisting of Outdoor Unit and Wall Mounted Indoor Unit - Furnish and install Refrigerant piping, interlock wiring and drain tubing - Furnish and install Linehide to cover refrigerant , drain and wire - Furnish and install Condenser Pad - Start up and check test of operation - 1 year labor warranty - 12 year limited manufacturer’s parts warranty
Perform comprehensive HVAC system repair and maintenance
This quote covers a comprehensive set of HVAC services, including: - Uninstallation and disposal of the old damaged coil. - Leak free installation of the new coil. - Full system testing and calibration for peak performance. - Uninstallation and disposal of the old damaged filter drier. - Leak free installation of the new filter drier. - Full system testing and calibration for peak performance. - Refrigerant leak detection. - Recover refrigerant. - Nitrogen purge. - Leak repair. - Pressure test. - All refrigerant recovery and recycling following EPA protocol. - Purging refrigerant lines with dry nitrogen. - Accurate refrigerant weigh in/out with calibrated scale. - Complete refrigerant testing for peak system operation using super heat and sub cooling diagnostics. - Adding refrigerant to EPA guidelines. - Remove schrader core with isolation tool. - Install new schrader core and new cap. - Leak test service valve.
Install a 20K BTU Mitsubishi multi-zone mini-split system with two indoor units
This quote is for the installation of a Mitsubishi multi-zone mini-split system with a 20K BTU outdoor heat pump and two indoor wall units. - Condenser: Mitsubishi 20K Multi Outdoor Heat Pump - Indoor Units: Two Mitsubishi Monty wall units (9,000 BTU each) - Included Components: Lisette, communication wire, plastic cover, starter loose elbow for plastic cover PVC, drainpipe, bracket for outdoor condenser - Installation Services: Leak test, vacuum pump, charge condenser with Freon - Warranty: One year labor warranty included