Is $900 to replace 14 inch motorized zone damper motor a fair price?
Project Details
I had my HVAC system (single unit/2 zone AC and gas heater) replaced in early spring because it couldn't maintain a comfortable temperature during hot summer months, even though multiple vendors said the old unit was working properly. The contractor I chose said there was an issue with undersized ductwork and increasing it would fix the problem. However, the new unit is performing worse than the old one. A representative investigated and noted the downstairs zone damper wasn't fully open. He thinks replacing it will correct the problem. The zone dampers and control board weren't replaced with the new unit, so they aren't under warranty. I think the quotes for replacement seem absurd, especially since a 14” damper with motor (Honeywell) is about $150 at the local supply store. Installation access seems relatively easy. I'm concerned this damper issue could have been the problem all along. If the contractor insists I pay, I'd rather get another contractor. The other zone (10”) is not suspect. Their current plan is to put a camera in the duct to look for anything binding the damper. Based on the numbers, I wonder if $600 would be reasonable for a complete replacement.
Quote Details
Replace the motor for the 14 inch motorized zone damper. Note: Further investigation determined the motor was good, making this quote potentially invalid.
You say...
Vote Distribution
These ratings are not endorsed by Quote Critic. They are submitted by other Quote Critic users like you.
Comments
No comments yet
Sign in to share your thoughts and ask questions.
Similar Quotes
Perform comprehensive HVAC system repair and maintenance
This quote covers a comprehensive set of HVAC services, including: - Uninstallation and disposal of the old damaged coil. - Leak free installation of the new coil. - Full system testing and calibration for peak performance. - Uninstallation and disposal of the old damaged filter drier. - Leak free installation of the new filter drier. - Full system testing and calibration for peak performance. - Refrigerant leak detection. - Recover refrigerant. - Nitrogen purge. - Leak repair. - Pressure test. - All refrigerant recovery and recycling following EPA protocol. - Purging refrigerant lines with dry nitrogen. - Accurate refrigerant weigh in/out with calibrated scale. - Complete refrigerant testing for peak system operation using super heat and sub cooling diagnostics. - Adding refrigerant to EPA guidelines. - Remove schrader core with isolation tool. - Install new schrader core and new cap. - Leak test service valve.
Replace two zone dampers
The quote is for the replacement of two zone damper units. The HVAC company diagnosed hot and cold spots in the house, identifying two dead Honeywell zone damper motors. The technician stated that the entire damper unit needs to be replaced, rather than just the motors/actuators, due to them being Honeywell units and potential compatibility issues with other brands. - Service: Zone damper replacement with installation - Number of units: 2 - Damper Brand: Honeywell
Replace a 16 inch Honeywell damper
This quote option is for the replacement of a 16 inch Honeywell damper. The technician stated that a closed damper could lead to pressure buildup, potentially causing the entire HVAC unit to blow.