Is $1,800 to install a UV light system to kill mold in the unit a fair price?
Project Details
I had a new unit, furnace, and ducts installed less than 2 years ago. The company that installed it provides free summer/winter checks. During a summer check, the technician showed me pictures of a small amount of mold on the inside of the blower in the hallway. He said it would get worse unless a UV light was installed to kill the mold, as it grows in cold, dark, and damp conditions. I questioned why the company didn't install a UV light initially, and he explained it was an add-on. I am questioning if this is a standard installation or if I am being overcharged. I did not go with the UV light, and the quote price is valid for 3 months.
Quote Details
This quote is for the installation of a UV light system. The system is proposed to kill mold found on the inside of the blower in the hallway unit. The technician stated that the mold would worsen without the installation of this system.
You say...
Vote Distribution
These ratings are not endorsed by Quote Critic. They are submitted by other Quote Critic users like you.
Comments
No comments yet
Sign in to share your thoughts and ask questions.
Similar Quotes
Perform comprehensive HVAC system repair and maintenance
This quote covers a comprehensive set of HVAC services, including: - Uninstallation and disposal of the old damaged coil. - Leak free installation of the new coil. - Full system testing and calibration for peak performance. - Uninstallation and disposal of the old damaged filter drier. - Leak free installation of the new filter drier. - Full system testing and calibration for peak performance. - Refrigerant leak detection. - Recover refrigerant. - Nitrogen purge. - Leak repair. - Pressure test. - All refrigerant recovery and recycling following EPA protocol. - Purging refrigerant lines with dry nitrogen. - Accurate refrigerant weigh in/out with calibrated scale. - Complete refrigerant testing for peak system operation using super heat and sub cooling diagnostics. - Adding refrigerant to EPA guidelines. - Remove schrader core with isolation tool. - Install new schrader core and new cap. - Leak test service valve.
Install a UV treatment for mold in air handler
This quote is for the installation of a UV treatment system to address suspected mold in the air handler. The technician showed photos of what he believes is mold. - Scope: Installation of a UV treatment system- Purpose: To address suspected mold in the air handler- Diagnosis: Based on technician's photos of suspected mold
Install a UV light filter
Installation of a UV light filter for the HVAC system. This recommendation was made by the technician due to a dirty blower, likely caused by recent renovation dust.