Is $3,089 to install surge protection and buck boost transformer a fair price?
Project Details
The homeowner is concerned about being overcharged for HVAC repairs and electrical upgrades. They have a Carrier Infinity 18 25VNA848 unit and have been told by an electrician that their electrical panel was a 'DIY' job by the previous owner, featuring double-tapped breakers and contributing to high winter electric bills ($600-750).
Quote Details
Electrical protection and voltage regulation for HVAC system: - Install surge protector for outdoor unit line voltage circuit (EAC-230) - Install single phase line monitor with built-in surge suppression, including new whip and up to 4' of feed line (EAC-115) - Install 7.81KVA buck boost transformer with surge device - Calibrate line voltage monitor and test system operation
You say...
Vote Distribution
These ratings are not endorsed by Quote Critic. They are submitted by other Quote Critic users like you.
More Details
Category
HVAC
Price
$3,089
Quote Date
April 24, 2026
Fuel type
Electric
Comments
No comments yet
Sign in to share your thoughts and ask questions.
Similar Quotes
Install Mitsubishi 9KBTU Hyperheat Mini Split Heat Pump System for one room
- Perform manual J Load calculation to understand true heating and cooling loads for the area of house served by the furnace - Furnish and install new Heatpump system consisting of Outdoor Unit and Wall Mounted Indoor Unit - Furnish and install Refrigerant piping, interlock wiring and drain tubing - Furnish and install Linehide to cover refrigerant , drain and wire - Furnish and install Condenser Pad - Start up and check test of operation - 1 year labor warranty - 12 year limited manufacturer’s parts warranty
Perform comprehensive HVAC system repair and maintenance
This quote covers a comprehensive set of HVAC services, including: - Uninstallation and disposal of the old damaged coil. - Leak free installation of the new coil. - Full system testing and calibration for peak performance. - Uninstallation and disposal of the old damaged filter drier. - Leak free installation of the new filter drier. - Full system testing and calibration for peak performance. - Refrigerant leak detection. - Recover refrigerant. - Nitrogen purge. - Leak repair. - Pressure test. - All refrigerant recovery and recycling following EPA protocol. - Purging refrigerant lines with dry nitrogen. - Accurate refrigerant weigh in/out with calibrated scale. - Complete refrigerant testing for peak system operation using super heat and sub cooling diagnostics. - Adding refrigerant to EPA guidelines. - Remove schrader core with isolation tool. - Install new schrader core and new cap. - Leak test service valve.
Install low and high volt surge protection for HVAC
Installation of surge protection for the HVAC unit, including both low voltage and high voltage protection.