Is $200 to perform a mini-split deep clean a fair price?
Project Details
The homeowner requested a mini-split cleaning due to mold/mildew growth. After an initial cleaning failed to remove the growth, the company suggested a 'deep clean'. The unit is approximately 5-6 years old and has only been used for two summers. The homeowner recently learned they should run the fan to dry the unit out before shutting it off.
Quote Details
Deep cleaning service for a mini-split unit to address mold and mildew growth. - Application of cleaning spray to unit fins - Inspection of internal growth and condensate drainage - Note: Tech indicated they do not typically disassemble units for internal coil cleaning
You say...
Vote Distribution
These ratings are not endorsed by Quote Critic. They are submitted by other Quote Critic users like you.
More Details
Category
HVAC
Price
$200
Quote Date
May 18, 2026
Year Built
2018
Fuel type
Electric
System type
Ductless mini Split
Comments
No comments yet
Sign in to share your thoughts and ask questions.
Similar Quotes
Install Mitsubishi 9KBTU Hyperheat Mini Split Heat Pump System for one room
- Perform manual J Load calculation to understand true heating and cooling loads for the area of house served by the furnace - Furnish and install new Heatpump system consisting of Outdoor Unit and Wall Mounted Indoor Unit - Furnish and install Refrigerant piping, interlock wiring and drain tubing - Furnish and install Linehide to cover refrigerant , drain and wire - Furnish and install Condenser Pad - Start up and check test of operation - 1 year labor warranty - 12 year limited manufacturer’s parts warranty
Perform comprehensive HVAC system repair and maintenance
This quote covers a comprehensive set of HVAC services, including: - Uninstallation and disposal of the old damaged coil. - Leak free installation of the new coil. - Full system testing and calibration for peak performance. - Uninstallation and disposal of the old damaged filter drier. - Leak free installation of the new filter drier. - Full system testing and calibration for peak performance. - Refrigerant leak detection. - Recover refrigerant. - Nitrogen purge. - Leak repair. - Pressure test. - All refrigerant recovery and recycling following EPA protocol. - Purging refrigerant lines with dry nitrogen. - Accurate refrigerant weigh in/out with calibrated scale. - Complete refrigerant testing for peak system operation using super heat and sub cooling diagnostics. - Adding refrigerant to EPA guidelines. - Remove schrader core with isolation tool. - Install new schrader core and new cap. - Leak test service valve.
Deep clean a mini split
Deep clean of the mini split.