Is $4,000 to add a zone to a Lennox 14ACX and ML180 system a fair price?
Project Details
We have a two story house that already has two units; however, the west side of the upstairs is always a lot hotter than the rest of the upstairs. The vents and air returns are set up in a way that no duct work needs to be changed and the new thermostat would be very close to the HVAC. I am wondering if a zone would work well on our system and if the cost seems reasonable.
Quote Details
The quote is for adding a zone to the existing two-story house with two units, specifically addressing the hotter west side of the upstairs. The current vent and air return setup means no ductwork changes are required, and the new thermostat will be close to the HVAC unit. The work includes: - Installation of a Honeywell zone control panel - Installation and wiring of motorized zone dampers (quantity based on system design) - Connection of individual thermostats for each zone - Integration with existing HVAC equipment and ductwork - Full zone configuration and system balancing - Final performance test and homeowner orientation
You say...
These ratings are not endorsed by Quote Critic. They are submitted by other Quote Critic users like you.
More Details
Category
HVAC
Price
$4,000
Quote Date
October 1, 2025
Brand/model
Lennox 14ACX and ML180
System type
Air conditioner, Furnace
Comments
No comments yet
Sign in to share your thoughts and ask questions.
Similar Quotes
Install Mitsubishi 9KBTU Hyperheat Mini Split Heat Pump System for one room
- Perform manual J Load calculation to understand true heating and cooling loads for the area of house served by the furnace - Furnish and install new Heatpump system consisting of Outdoor Unit and Wall Mounted Indoor Unit - Furnish and install Refrigerant piping, interlock wiring and drain tubing - Furnish and install Linehide to cover refrigerant , drain and wire - Furnish and install Condenser Pad - Start up and check test of operation - 1 year labor warranty - 12 year limited manufacturer’s parts warranty
Perform comprehensive HVAC system repair and maintenance
This quote covers a comprehensive set of HVAC services, including: - Uninstallation and disposal of the old damaged coil. - Leak free installation of the new coil. - Full system testing and calibration for peak performance. - Uninstallation and disposal of the old damaged filter drier. - Leak free installation of the new filter drier. - Full system testing and calibration for peak performance. - Refrigerant leak detection. - Recover refrigerant. - Nitrogen purge. - Leak repair. - Pressure test. - All refrigerant recovery and recycling following EPA protocol. - Purging refrigerant lines with dry nitrogen. - Accurate refrigerant weigh in/out with calibrated scale. - Complete refrigerant testing for peak system operation using super heat and sub cooling diagnostics. - Adding refrigerant to EPA guidelines. - Remove schrader core with isolation tool. - Install new schrader core and new cap. - Leak test service valve.
Create two zones in my HVAC system with EWC control and automated dampers
This quote proposes to create two zones in your existing HVAC system. It includes a 5-year system warranty and a 1-year labor warranty.The scope of work includes: - EWC control panel: Model NCM300 - Dampers: Two 18x8” automated dampers - Thermostat setup: Second floor will be controlled by an owner-provided Ecobee thermostat, installed next to the first-floor thermostat - Temperature sensing: Readings for the second floor will come from an owner-provided wireless remote sensor on the second floor - Wiring: Included low voltage wiring - Insulation: R-8 insulation on the supply duct tee in the attic - Duct Repair: Repair of any missing duct insulation in the attic