Is $15,302 to install a lennox elite line el19 variable capacity heat pump system a fair price?
Project Details
My current system is 18 years old and only services the upstairs of our house. Located in North Potomac, Maryland.
Quote Details
Installation of a 2-ton variable capacity heat pump system in the attic. - Lennox 2 Ton Elite Heat Pump System Up To 19.5 SEER2 (A2L) - Single Phase Outdoor Surge Protector - Flush existing refrigerant lines prior to new system installation - Install "Ceiling Saver" protection package - Lennox S40 Thermostat - 10 Year Parts, 5 Year Labor, and 1 YEAR Whole Home PRIME warranty - Includes PEPCO Lennox Air Source Heat Pump Tier 2 Instant Rebate and various GAC/PRIME discounts
You say...
Vote Distribution
These ratings are not endorsed by Quote Critic. They are submitted by other Quote Critic users like you.
More Details
Category
HVAC
Price
$15,302
Quote Date
May 23, 2026
Location
Maryland
Brand/model
Lennox Elite EL19
BTU tonnage
2 Ton
Efficiency rating
19.5 SEER2
Fuel type
Electric
Labor warranty
5
Parts warranty
10
System type
Heat pump
Comments
No comments yet
Sign in to share your thoughts and ask questions.
Similar Quotes
Install Mitsubishi 9KBTU Hyperheat Mini Split Heat Pump System for one room
- Perform manual J Load calculation to understand true heating and cooling loads for the area of house served by the furnace - Furnish and install new Heatpump system consisting of Outdoor Unit and Wall Mounted Indoor Unit - Furnish and install Refrigerant piping, interlock wiring and drain tubing - Furnish and install Linehide to cover refrigerant , drain and wire - Furnish and install Condenser Pad - Start up and check test of operation - 1 year labor warranty - 12 year limited manufacturer’s parts warranty
Perform comprehensive HVAC system repair and maintenance
This quote covers a comprehensive set of HVAC services, including: - Uninstallation and disposal of the old damaged coil. - Leak free installation of the new coil. - Full system testing and calibration for peak performance. - Uninstallation and disposal of the old damaged filter drier. - Leak free installation of the new filter drier. - Full system testing and calibration for peak performance. - Refrigerant leak detection. - Recover refrigerant. - Nitrogen purge. - Leak repair. - Pressure test. - All refrigerant recovery and recycling following EPA protocol. - Purging refrigerant lines with dry nitrogen. - Accurate refrigerant weigh in/out with calibrated scale. - Complete refrigerant testing for peak system operation using super heat and sub cooling diagnostics. - Adding refrigerant to EPA guidelines. - Remove schrader core with isolation tool. - Install new schrader core and new cap. - Leak test service valve.
Install a 2-ton lennox dual fuel system with new ductwork
Full HVAC installation including a Lennox EL18KSLV heat pump and Lennox ML180 furnace. - Lennox EL18KSLV 2-ton variable capacity heat pump (SEER2 16.2, HSPF2 8.5) - Lennox ML180 80% AFUE single stage furnace (66k BTU) - New ductwork package including trunk, supplies, and returns (up to 8 runs) - New electrical disconnect, whip, and pad - New venting, gas piping, and condensate lines - Ecobee thermostat and MERV 11 filter - 10-year parts and labor warranty - R-454B refrigerant (2025 compliant)