Is $6,000 to install a Mitsubishi 1-ton mini split unit a fair price?
Project Details
I'm looking to install a mini split in my garage but am noticing a wide range of pricing not only for units but also to have someone install one. I was also looking at units and some 9-12K units were anywhere from $500 - $2500. I'm confused about what makes some of these units so much more expensive, if it's only brand name and repairability, and if cheaper units are not repairable (replacement parts not available).
Quote Details
This quote is for the installation of a Mitsubishi brand 1-ton mini split unit. The company mentioned that brands like Mitsubishi are repairable.
You say...
Vote Distribution
These ratings are not endorsed by Quote Critic. They are submitted by other Quote Critic users like you.
More Details
Category
HVAC
Price
$6,000
Quote Date
June 19, 2025
Brand/model
Mitsubishi
BTU tonnage
1 Ton
Efficiency rating
1-ton
Fuel type
Electric
System type
Ductless mini Split
Comments
No comments yet
Sign in to share your thoughts and ask questions.
Similar Quotes
Install Mitsubishi 9KBTU Hyperheat Mini Split Heat Pump System for one room
- Perform manual J Load calculation to understand true heating and cooling loads for the area of house served by the furnace - Furnish and install new Heatpump system consisting of Outdoor Unit and Wall Mounted Indoor Unit - Furnish and install Refrigerant piping, interlock wiring and drain tubing - Furnish and install Linehide to cover refrigerant , drain and wire - Furnish and install Condenser Pad - Start up and check test of operation - 1 year labor warranty - 12 year limited manufacturer’s parts warranty
Perform comprehensive HVAC system repair and maintenance
This quote covers a comprehensive set of HVAC services, including: - Uninstallation and disposal of the old damaged coil. - Leak free installation of the new coil. - Full system testing and calibration for peak performance. - Uninstallation and disposal of the old damaged filter drier. - Leak free installation of the new filter drier. - Full system testing and calibration for peak performance. - Refrigerant leak detection. - Recover refrigerant. - Nitrogen purge. - Leak repair. - Pressure test. - All refrigerant recovery and recycling following EPA protocol. - Purging refrigerant lines with dry nitrogen. - Accurate refrigerant weigh in/out with calibrated scale. - Complete refrigerant testing for peak system operation using super heat and sub cooling diagnostics. - Adding refrigerant to EPA guidelines. - Remove schrader core with isolation tool. - Install new schrader core and new cap. - Leak test service valve.
Install a single head 3 ton Mitsubishi mini split unit
This quote is for the installation of a single head 3 ton Mitsubishi mini split unit.