Is $500 to install a hard start kit a fair price?
Project Details
I had an inspection done on my 2016 Lennox HVAC unit. The technician recommended installing a hard start kit to extend the life of the compressor, even though he stated the unit is cooling very well. I am questioning the necessity and effectiveness of this recommendation, as it seems like a sales ploy given the $500 price tag and the fact that technicians might be paid on commission.
Quote Details
This quote is for the installation of a compressor saver, also known as a hard start kit, to extend the life of the HVAC compressor. The recommendation was made after an inspection of a 2016 Lennox HVAC unit. - HVAC Unit: 2016 Lennox - Inspection Findings: Thermostat set to 70 degrees, home temperature 70 degrees, good temperature split (70/50), all motors, capacitor, compressor, and coils checked. - Problem Identified: High inrush current - Recommendation: Install a compressor saver (hard start kit) to extend compressor life. - Current System Status: System is cooling very well at this time.
You say...
Vote Distribution
These ratings are not endorsed by Quote Critic. They are submitted by other Quote Critic users like you.
More Details
Category
HVAC
Price
$500
Quote Date
July 30, 2025
Location
Arizona
Brand/model
Lennox
System type
Air conditioner
Comments
No comments yet
Sign in to share your thoughts and ask questions.
Similar Quotes
Perform comprehensive HVAC system repair and maintenance
This quote covers a comprehensive set of HVAC services, including: - Uninstallation and disposal of the old damaged coil. - Leak free installation of the new coil. - Full system testing and calibration for peak performance. - Uninstallation and disposal of the old damaged filter drier. - Leak free installation of the new filter drier. - Full system testing and calibration for peak performance. - Refrigerant leak detection. - Recover refrigerant. - Nitrogen purge. - Leak repair. - Pressure test. - All refrigerant recovery and recycling following EPA protocol. - Purging refrigerant lines with dry nitrogen. - Accurate refrigerant weigh in/out with calibrated scale. - Complete refrigerant testing for peak system operation using super heat and sub cooling diagnostics. - Adding refrigerant to EPA guidelines. - Remove schrader core with isolation tool. - Install new schrader core and new cap. - Leak test service valve.
Install Mitsubishi 9KBTU Hyperheat Mini Split Heat Pump System for one room
- Perform manual J Load calculation to understand true heating and cooling loads for the area of house served by the furnace - Furnish and install new Heatpump system consisting of Outdoor Unit and Wall Mounted Indoor Unit - Furnish and install Refrigerant piping, interlock wiring and drain tubing - Furnish and install Linehide to cover refrigerant , drain and wire - Furnish and install Condenser Pad - Start up and check test of operation - 1 year labor warranty - 12 year limited manufacturer’s parts warranty
Install a hard start kit
This quote is for the installation of a hard start kit on a 4-ton Carrier AC system. The service is recommended to address a high Locked Rotor Amps (LRA) reading of 124A, which is above the rated 110A, causing lights to dim and a loud clack from the condenser unit on startup. The AC system is approximately 5 years old. - Service: Installation of a hard start kit- Purpose: To address high LRA on a 4-ton Carrier AC system- Current LRA: 124A (rated 110A)- Symptoms: Lights dimming on startup, loud clack from condenser unit- AC System Age: Approximately 5 years old