Is $5,000 to replace AC system due to bad air handler control board and fan motor a fair price?
Project Details
I am looking for a second opinion on an HVAC diagnosis. My system was not heating properly, and a vendor inspected it, stating the air handler control board and fan motor are bad, recommending a full AC replacement. I am questioning if a failed control board and fan motor typically justify a full system replacement, or if repair is usually reasonable. I also wonder if it's common practice to recommend replacement without clearly showing why both components are confirmed bad, and what diagnostics a tech should run or show before calling a system "done". I am trying to understand if this recommendation passes the smell test before spending ~$5k.
Quote Details
This quote is for a full AC system replacement. The vendor diagnosed the issue as a bad air handler control board and fan motor, which is causing the system to not heat properly. The quote mentions the possibility of reusing the existing condenser unit for parts or performing a regular install. - Diagnosis: Air handler control board and fan motor are bad - Problem: System not heating properly - Scope: Full AC system replacement - Condenser Unit: Can be used for parts or a regular install - Diagnostic Details: No detailed electrical readings, fault codes, or failure explanation provided
You say...
Vote Distribution
These ratings are not endorsed by Quote Critic. They are submitted by other Quote Critic users like you.
More Details
Category
HVAC
Price
$5,000
Quote Date
February 2, 2026
System type
Air conditioner
Comments
No comments yet
Sign in to share your thoughts and ask questions.
Similar Quotes
Perform comprehensive HVAC system repair and maintenance
This quote covers a comprehensive set of HVAC services, including: - Uninstallation and disposal of the old damaged coil. - Leak free installation of the new coil. - Full system testing and calibration for peak performance. - Uninstallation and disposal of the old damaged filter drier. - Leak free installation of the new filter drier. - Full system testing and calibration for peak performance. - Refrigerant leak detection. - Recover refrigerant. - Nitrogen purge. - Leak repair. - Pressure test. - All refrigerant recovery and recycling following EPA protocol. - Purging refrigerant lines with dry nitrogen. - Accurate refrigerant weigh in/out with calibrated scale. - Complete refrigerant testing for peak system operation using super heat and sub cooling diagnostics. - Adding refrigerant to EPA guidelines. - Remove schrader core with isolation tool. - Install new schrader core and new cap. - Leak test service valve.
Install Mitsubishi 9KBTU Hyperheat Mini Split Heat Pump System for one room
- Perform manual J Load calculation to understand true heating and cooling loads for the area of house served by the furnace - Furnish and install new Heatpump system consisting of Outdoor Unit and Wall Mounted Indoor Unit - Furnish and install Refrigerant piping, interlock wiring and drain tubing - Furnish and install Linehide to cover refrigerant , drain and wire - Furnish and install Condenser Pad - Start up and check test of operation - 1 year labor warranty - 12 year limited manufacturer’s parts warranty
Replace the entire HVAC system
This quote is for a full HVAC system replacement, including: - Replace condenser - Replace compressor - Replace coil assembly - Replace furnace - Additional unspecified components