Is $10,000 to install a roofing patio membrane a fair price?
Project Details
I just had a roofing patio installed due to a leak and wear on the old one. I'm concerned about the seam in the new membrane and potential leaks, and I'm not sure if the installation is acceptable for the price. The job was done on the 4th floor of a townhouse. This quote was the lowest I received, with most others being around $12k-$14k.
Quote Details
Installation of a new walkable roofing membrane on a 4th-floor patio due to a leak and wear on the old one. The material used is Dec-Tec Classic 60 Mil roofing membrane in Solid Grey. - Removal of the bottom three courses of siding and J-channels on the walls of the upper rear walk-out patio. - Siding to be set aside for later reinstallation. - Removal of one layer of walkable membrane down to the bare wood. - No work to be done on any other section of the home. - Replacement of one piece of ¾” plywood at the corner where the leak is currently occurring. - All wood surfaces will be prepared to ensure a smooth application of the new membrane. - Install Dec-Tec Classic 60 Mil roofing membrane in Solid Grey.
You say...
Vote Distribution
These ratings are not endorsed by Quote Critic. They are submitted by other Quote Critic users like you.
More Details
Category
Roofing
Price
$10,000
Quote Date
May 21, 2025
Location
Maryland
Tearoff included?
No
Comments
No comments yet
Sign in to share your thoughts and ask questions.
Similar Quotes
Install a walkable pvc membrane (duradek/dec-tec)
A single-layer, heat-welded sheet membrane installation for a 50-60 sq ft balcony. - Heat-welded sheet membrane application - Labor cost: $1,200 - $1,800 - Materials cost: ~$700 (homeowner supplied)
Install a walkable pvc membrane (duradek/dec-tec)
A single-layer, heat-welded sheet membrane installation. - Labor cost: $1,200 - $1,800 - Material cost: ~$500 (homeowner supplied) - Total estimated cost: $2,300
Replace flat roof/balcony with DecTec and reuse existing railings
This quote is for ripping and replacing an existing 3-square (300 sqft) flat roof/balcony. The work includes: - Replacing all existing plywood. - Installing DecTec material. - Reusing the existing rail system.